Bug Fixes History

Fixed an issue related to loading Extended Port Info section

Fixed an issue related to supporting more than 255 SMP MADs on the wire

• Fixed an issue related to progress bar overlap in PHY plugin

• Fixed fatal error in case of invalid plane number in Hierarchy information

• Fixed an error message about unexpected link speed

• Fixed an issue related to ibnetsplit core dump

There are no new bug fixes in this version. For a list of old bug fixes, please see Bug Fixes History.

• Fixed an issue related to several core dumps that occurred when capabilities were lost

• Fixed an issue related to DFP islands creation

• Fixed an issue related to TX Bias report conversion

• Fixed wrong port speed in case of timeouts in fabric

• Fixed cable RX/TX Power uW to mW conversions

• No bug fixes are introduced in this release

• No bug fixes are introduced in this release

• Fixed HCA selection by the "Auto Scope Builder" (--host_file & --node_descr_filter)

• Fixed an issue related to fetching PortVLXmitTimeCongExt counter

• Fixed FLIDs validation

• Fixed an issue related to unhealthy reporting mode

• Fixed dump dv_csv sections when the scope exists

• Fixed an issue related to the execute command from the switches

• Fixed an issue related to fetching multiple Congestion Control counters 

• Fixed PEMI register handling

• Fixed SLRIP register

• Fixed PDDR registers layouts

• Fixed an issue related to the execute command from the switches

• Fixed an issue related to fetching multiple Congestion Control counters

• Fixed an issue related to loading the 'HWInfo.technology' field from a file.

• Removed 'PERF' records duplicates in the 'db_csv' file.

• Fixed an issue related to retrieving RX/TX Power fields in the cable report

• Fixed a crash in SHARP stage that occurred when one or more switches was reset

• Fixed the DB_CSV file which contained non-ASCII characters

• Fixed PCIe plugin behavior to support scope file

• Fixed the wrong number of SHARP active jobs in fabric summary

• Fixed an unexpected exit when detected HCAs with invalid GUID in discovery stage

• Fixed an issue that corrupted the ibdaignet reporting for other nodes when encountering an HCA with an invalid LID

• Fixed a possible crash in SHARP validation mode when SHARP version is not specified in command line parameters

• Fixed the wrong values in "switchguid" and in "remote port" fields in ibnetdiscover file

• Fixed an issue that caused ibtopodiff not to recognize IB Routers

• Fixed the reset flow for PHY/PCI counters

• Fixed an issue that resulted in GUIDs being printed in Mkey Mmanager in HEX format

• Fixed an issue that resulted in error messages being printed with the correct node GUID instead of the value "zero"

• Fixed an issue that loaded duplicates and half links from the neighbors file of MKey manager

• Fixed an issue that printed errors/warning status in stages

• Fixed an issue that resulted in a critical error in case of duplicate names with HCA/mlx patterns

• Fixed an issue that caused ibdiagnet to skip PCIe counters for some HCAs, if more than one HCA was installed in the host.

• Fixed an issue that caused ibdiagnet to report a wrong value for SLRG 16nm register.

• Fixed an issue that caused ibdiagnet to report a wrong value in SMP access register.

• Fixed an issue that caused ibdiagnet to report a wrong number of “Aggregation Nodes” in “Fabric Summary” table