|
Internal Ref. |
Issue |
|---|---|
|
4812446 / 4917369 |
Description: Fixed an issue where CREATE_PARSE_GRAPH_NODE incorrectly applied validation intended for WA mode, in which Validation is now mode-specific: normal-mode rules are applied on ConnectX-8 and newer adapters, while WA-mode rules are applied on older adapters. |
|
Keywords: Parse graph node |
|
|
Detected in version: 82.48.1000 |
|
|
Fixed in Release: 82.49.1014 |
|
|
4864823 / 4858750 |
Description: Fixed an issue where, when Flex Parser overwrite native arc was enabled, destroying or closing a parse graph node on a native protocol arc did not restore the native protocol parser. As a result, the native parser remained unavailable on the device until a reset or another recovery action was performed. Native protocol parsing is now restored as expected when the parse graph node is closed or destroyed. Native parsers are disabled only while the Flex Parser graph owns the arc. |
|
Keywords: Flex Parser |
|
|
Detected in version: 82.48.1000 |
|
|
Fixed in Release: 82.49.1014 |
|
|
4895996 / 4965646 / NVBug 5919232 |
Description: Fixed an issue where the MCU sometimes NACKed I2C MCTP transactions. A retry mechanism has been implemented for NACK cases. |
|
Keywords: MCU, NACK |
|
|
Detected in version: 82.48.1000 |
|
|
Fixed in Release: 82.49.1014 |
|
|
4902573 |
Description: Fixed an issue where executing CancelComponentUpdate during the firmware burn FSM_RET_BUSY window caused firmware to return error 0x84 (Invalid state) and left WP disabled. |
|
Keywords: PLDM update, WP |
|
|
Detected in version: 82.48.1000 |
|
|
Fixed in Release: 82.49.1014 |
|
|
4964566 / 4957757 |
Description: Fixed a DEAD IRISC assert that could occur during TLV NV_DATA flash access by suspending the watchdog while waiting for flash IPC (until timeout), preventing the assert on TLV access. |
|
Keywords: DEAD IRISC assert |
|
|
Detected in version: 82.48.1000 |
|
|
Fixed in Release: 82.49.1014 |
|
|
4835832
|
Description: In rare cases, certain module types may experience link-up failures. |
|
Keywords: Cables |
|
|
Detected in version: 82.48.1000 |
|
|
Fixed in Release: 82.49.1014 |
|
|
4871267 / 4871254 |
Description: Fixed an issue where ICM_RES_HW_DMFS_ENCAP_H_FW was allocated per GVMI, preventing some RTTs from using it. |
|
Keywords: GVMI, RTT |
|
|
Detected in version: 82.48.1000 |
|
|
Fixed in Release: 82.49.1014 |
|
|
4860860 |
Description: Fixed an issue where queue pairs (QPs) created during a PCC process transition could miss congestion-control (CC) information, preventing them from being fully managed. |
|
Keywords: DOCA, PCC, QP, Congestion Control |
|
|
Detected in version: 82.48.1000 |
|
|
Fixed in Release: 82.49.1014 |
|
|
4789601 / 4850200 / NVBug 5736447 |
Description: Fixed an issue where RDMA traffic could stall in large-scale deployments for certain source IP and UDP source-port combinations when DOCA PCC was active and no congestion-control algorithm was configured in algorithm slot 0. |
|
Keywords: RDMA, DOCA PCC, Congestion Control Algorithm |
|
|
Detected in version: 82.48.1000 |
|
|
Fixed in Release: 82.49.1014 |
|
|
4796182 |
Description: Fixed an issue where the live migration target did not receive a port state change event on the resume VHCA command. The target now generates this event so software that depends on port state is notified of any changes. |
|
Keywords: Live migration |
|
|
Detected in version: 82.48.1000 |
|
|
Fixed in Release: 82.49.1014 |
|
|
4867472 / 4847702 / 4642994 / 4859742 |
Description: Fixed an issue during hitless upgrade where, after the SACK generation/handler fence, firmware could mark the old port configuration ID as invalid. If SACK causes were still active, a race could cause SACK ISRs to stop unexpectedly. The fix is to always return BUSY while handover is active. |
|
Keywords: Hitless upgrade |
|
|
Detected in version: 82.48.1000 |
|
|
Fixed in Release: 82.49.1014 |
|
|
4873533 / 4947034 |
Description: Fixed an issue where, when using multiplane ZTRCC congestion control with multiple flows, the RTT timeout counter in the PPCC register could increase even when the network was not congested. |
|
Keywords: Congestion control, multiplane, SPCX CC, RTT, PPCC |
|
|
Detected in version: 82.48.1000 |
|
|
Fixed in Release: 82.49.1014 |
|
|
4843342 / 4970550 |
Description: Fixed an issue where one-to-one RoCE traffic using a single QP might not achieve line rate on some platforms when using the default ROCE_CC_COMPATIBILITY_MODE setting in mlxconfig. |
|
Keywords: Congestion control, PCC, ROCE_CC_COMPATIBILITY_MODE |
|
|
Detected in version: 82.48.1000 |
|
|
Fixed in Release: 82.49.1014 |
Last updated: